Bulkhead installation

Discussion in 'Filtration, & Other Equipment' started by Kirk_M, Apr 13, 2006.

  1. Kirk_M

    Kirk_M Chevron Tang LARC Supporter

    Messages:
    7,633
    Likes Received:
    106
    Location:
    Mandeville, LA
    Should silicone be used on a bulkhead after it has been tightened down or not? I know the gasket goes towards the wet side, but, is this enough to keep leakage from occuring? My first setup, done by George, had silicone EVERYWHERE, but, I have read that it is not needed or recommended, though some people swear you need it.

    Thanks,

    Kirk
     
  2. Kirk_M

    Kirk_M Chevron Tang LARC Supporter

    Messages:
    7,633
    Likes Received:
    106
    Location:
    Mandeville, LA
    Thanks...
     

Share This Page